Crystal report run [message #536048] |
Mon, 19 December 2011 02:12 |
mahmud732
Messages: 82 Registered: October 2009 Location: Dhaka
|
Member |
|
|
Dear all,
I want to run a report developed by crystal reports by click on a button in oracle developer 6i.
Is it possible. If yes then how can i do this. Please help me.
Regards
Mahmud.
|
|
|
|
|
|
|
|
Re: Crystal report run [message #536109 is a reply to message #536107] |
Mon, 19 December 2011 04:26 |
mahmud732
Messages: 82 Registered: October 2009 Location: Dhaka
|
Member |
|
|
"If you know how to do that, include that command line into HOST built-in (in WHEN-BUTTON-PRESSED trigger), supply parameters and that should do it."
I don't know how to do that.Which code is to be written in WHEN-BUTTON-PRESSED trigger?
|
|
|
Re: Crystal report run [message #536113 is a reply to message #536109] |
Mon, 19 December 2011 04:47 |
cookiemonster
Messages: 13938 Registered: September 2008 Location: Rainy Manchester
|
Senior Member |
|
|
The code you would use to run crystal reports from the command line.
If you don't know what that is I suggest you look in the crystal documentation or try a crystal forum online.
This is an oracle forum and most of us don't use crystal.
If you're lucky someone here will know and tell you but I suggest you start looking elsewhere.
|
|
|
Re: Crystal report run [message #536116 is a reply to message #536113] |
Mon, 19 December 2011 05:05 |
|
Littlefoot
Messages: 21818 Registered: June 2005 Location: Croatia, Europe
|
Senior Member Account Moderator |
|
|
I Googled a little bit and it appears that Crystal Reports doesn't have a command line utility which would allow you to run it from the command line. Also, I found 3rd party tools which are capable of doing that job.
Therefore, as far as I can tell, it seems that you'd have to buy a missing part, or forget about running Crystal Reports from a form.
|
|
|